青岛东方之星酒店:哪位大侠能帮小弟翻译下这些计算机专业内容

Warning W2533 - The system has host controllers that have not been enabled by the BIOS/OS. It may be possible to obtain information by querying devices (if any) attached to these host controllers if they were to be enabled.
Fix: Check BIOS settings and enable the host controllers. Or change Sandra options to enable them.
Warning 1206 - Device latency is high - the higher the latency, the more data a device can transfer in one go. The device may be hogging the bus for too long. Some video card drivers set the latency high in order to perform faster. The problem is that other devices (especially sound cards, network) won抰 have enough time to transfer their data resulting in lower performance (e.g. sound drop outs, lockup). Generally, all devices should have latency of 32, with high performance devices (e.g. video card, disk, giga-LAN) with 64 and AGP to 128.
Fix: Go to BIOS Setup\Settings\PCI & AGP Devices and reduce PCI latency to 64 or 32. Contact the mainboard manufacturer or video card manufacturer for more details.
Tip T319 - Usually, a refresh rate of 75Hz or more is necessary to completely remove flicker from monitor screens - depending on resolution, the brightness of the display and the person itself. If you have a flat-panel (LCD) display ignore this tip.
Fix: Switch to a higher refresh rate from Control Panel\Display\Display Properties\Settings, click Advanced Properties\Adapter. Choose the highest supported.
Tip T323 - Unless you have a lot of RAM and computing power, using a desktop wallpaper consumes memory and decreases the display speed since it must be re-painted when needed.
Fix: Go to Control Panel\Display\Display Properties\Background set the Wallpaper to (none).
Warning W1601 - This process consumes a huge amount of memory.
Fix: If you have many processes like this one, make sure you have enough physical memory to sustain them. Otherwise the system performance may decrease due to lack of memory.
Error E3000: Could not connect to database server.
Fix: Make sure the database connection settings are correct (check spelling). Check server is on-line and reachable by using the database test utilities supplied. Check that the credentials specified are correct and allow remote connection.
Notice N2536 - The system has no enabled SMBus/i2c/BMB controller or Sandra does not support it. Most modern systems have at least one.
Fix: If Warning W2533 is also issued, see its topic. If not check the manual to check whether such a controller is present; if it is please contact us.
Tip T212 - The BIOS can be shadowed. Shadowing is a technique of copying the BIOS program from slow EPROM or EEPROM to RAM. This may yield some increase in performance.
Fix: Go to BIOS set-up and make sure that System BIOS is both shadowed and cached