老版超人电影在线观看:请高手帮忙翻译6

来源:百度文库 编辑:神马品牌网 时间:2024/04/28 15:07:39
Leaching CuAl2 particles at 273K for 16 h resulted ina uniform copper carrier, which contained nearly 98 wt.%metallic copper and for which the copper surface area was14m2/g [17]. The AAS measurements showed that Cr additiveachieved the highest loading (2.2 wt.% Cr2O3) on thesurfaces of skeletal copper particles. However, for Zn andCo additives, a maximum deposition of around 1.0 wt.%was achieved.

The relationships between the additive loadings and theapparent copper and BET surface areas are shown in Fig. 1.Taking into account the data in Table 1 for the surface areasof the individual additives suggests that increasing amountsof the additives will increase the BET surface areas of thepromoted catalysts, as shown in Fig. 1.

Furthermore, coverage of the copper surface with precipitatedoxides should decrease the apparent copper urfacearea, as observed in Fig. 1, for catalysts containing ZnO andCr2O3, with the greatest effect being observed for Cr2O3.The result for the Co additive showed an increase in coppersurface area with increased CoO loading, which was notexpected.

In the case of Co additive, the increase of apparent coppersurface area probably resulted from the presence of metalliccobalt, which arises from reduction of cobalt oxide underpretreatment (Eq. (5)) when it is deposited on the highlydispersed surface of copper. Metallic cobalt would react with
一楼稍加修改我就可以接受了,麻烦你了。

大家请注意,某些查不到的词可能是两个单词中间缺少空格而引起的。

一楼的是机器翻译吧,我是手工啊,逐渐成为化学高手了,呵呵。
在 273 K 温度下过滤 CuAl2 粒子16小时将会产生一个均衡的铜载体,它包含了将近 98 wt.% 的金属铜,而且铜的表面为14m2/g[17]。AAS测量表明铬添加剂在骨骼铜颗粒表面达到最高的携带值(2.2 wt.%Cr2O3)。然而锌和钴添加剂可以获得大约1.0 wt.%的最大沉积物。

图1显示了添加剂负载与铜和BET表面区域的关系。考虑到表1中单一添加剂获得的表面区域的数据,我们可以得出,增加添加剂的数量将会增加被推进的催化剂的BET表面区域,如图1所示。

此外,从图1我们还可以看到,对于含氧化锌和三氧化二铬的催化剂,铜表面覆盖了沉淀氧化物将会导致铜表面区域的减少,而且三氧化二铬的催化剂的减少量更大。钴添加剂的数据表明,增大氧化钴的负载将会增加铜表面区域,这是一个意外发现。

在钴添加剂的试验中,铜表面区域的增加也许是归因于金属氧化物的存在,该氧化物是因在预处理期间(公式5)钴氧化物高度分散于铜表面而导致氧化物的的减少而产生。金属氧化物将会与××反应。

为 16 h 在 273 K 过滤 CuAl2 粒子产生 ina 制服铜运送者,包含了将近 98 wt 。% 金属的铜和铜升至水面区域 was14m2/ g[17]. AAS 测量表示 Cr additiveachieved 最高的载入 (2.2 wt。%Cr2O3) 在骨骼铜粒子的 thesurfaces 上。 然而,对于 Zn andCo 添加剂,大约 1.0 wt 的最大沈淀。%被达成。

关系在添加剂载入和 theapparent 铜之间而且打赌表面的区域在图 1 中被显示.进入帐户之内轮流在表 1 中的数据为表面的 areasof 个别的添加剂意味着逐渐增加的 amountsof 添加剂将会增加打赌 thepromoted 催化剂的表面区域,如图 1 所示.

此外,铜的报导以 precipitatedoxides 升至水面应该减少明显的铜 urfacearea,如图 1 所观察,对于包含 ZnO andCr2O3 的催化剂,藉由被为 Cr2O3 观察的最好效果。为 Co 添加剂的结果用增加的 CoO 载入表示 coppersurface 区域的增加,是 notexpected 。

在 Co 添加剂的情况,明显 coppersurface 区域的增加或许起因于 metalliccobalt 的出现, 从钴氧化物 underpretreatment 的减少发生 (情绪商数。 (5))当它在铜的 highlydispersed 表面上被存放的时候。 金属的钴会反应由于

浸出CuAl2 微粒在273K 为16 h 收效了ina 一致的铜载体, 哪些包含了几乎98 重量。%metallic 铜和为哪些铜表面was14m2/g [ 17 ] 。 AAS 测量表示, Cr additiveachieved 最高的装货(2.2 重量。% Cr2.O3) 在骨骼铜微粒thesurfaces 。 但是, 为Zn andCo 添加剂, 大约1.0 重量的最大证言。%was 达到了。
关系在叠加性装货和theapparent 铜之间和赌注表面被显示在无花果。 1.考虑到数据在表1 为表面areasof 各自的添加剂建议那增长的amountsof 添加剂将增加表面thepromoted 催化剂的赌注, 依照被显示在无花果。 1.
此外, 铜表面的覆盖面以precipitatedoxides 应该减少明显的铜urfacearea, 依照被观察在无花果。 1, 为催化剂包含ZnO andCr2.O3, 与最了不起的作用对Cr2.O3 被观察。结果为Co 添加剂显示了在coppersurface 区域的增量以增加的鸪鸪声装货, 哪些是notexpected 。
在Co 添加剂情况下, 明显的coppersurface 区域增量大概起因于metalliccobalt 出现, 哪些出现从钴氧化物underpretreatment 的减少(Eq. (5)) 当它被放置在highlydispersed 铜表面。 金属钴会起反应与